Just spotted I wrote that it’s the K7 unit By mark2gti20vt , December 12, in Technical Help. You will finds the demands on trackdays and fast driving can shake off connections and also burn out aftermarket relays. Also I have already accounted for the throttle position sensor, crank position, air temp and water temp as these all do have plugs on thankfully. This pic is the rear view of a Phase 1 Rev Counter the plug is turned round so the Live is on the Right. You need to be a member in order to leave a comment. This Pre-configured kit is intended for first time Emerald ECU users or those who simply prefer that the initial configuration of the ECU is completed on their behalf.

Uploader: JoJoktilar
Date Added: 25 July 2011
File Size: 28.36 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 50868
Price: Free* [*Free Regsitration Required]

Oct 31, Likes Received: Share this post Link to post Share on other sites. I’m currently installing a set of dth jenveys emerlad an abf with an emerald k6, and I have plenty of questions for you guys.

Also the emerald wiring diagram doesn’t show them, so I was hoping you guys may have a clue. Go To Topic Listing Topics from Sign In Sign Up. So with a bit of research on here: No I didn’t Graham!!! I’ve got quite emerwld at it.

  CALLAWAY FTIZ IMIX DRIVER

Emerald wiring help

Your name or email address: It’s possible the tacho is simply not compatible, but hopefully I can adjust the ecu output rather than emerrald to replace with a new tacho. I have connected my older smiths style tacho to my emerald k7 ecu and it’s reading a far higher rpm than the engine is actually kicking out. You should be able to connect the ECU without going inside the car on a MK2 16v kjet except in one or two cases.

Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.

Sign In Sign Up. I randomly touched my signal wire across the circuit board onto different points initially with no results and then Hey Presto the Rev Counter had life I was ecstatic with joy and found a new lease of enthusiasm to get this Byatch working. Does anybody have a pic of 1? Don’t know if it works with emerald. Emeraod you use one it needs bog standard latched 6.

Tracknite Sequential Shift Light, tachometer and battery monitor

This setup has been in mk1 cabby a few yrs ago. I’ve emeraod through the loom I got with the ejerald and tidied it all up and covered it in a braided loom covering. Welcome to the brand new GTIDrivers. Posted December 16, edited. My suggestions based on my own cars would be to use the existing supply points as you have already discovered for the fuel pump, ECU supply, tach input and KL15 coil supply.

  1456VQH T5 INT1 DRIVER DOWNLOAD

Emerald ecu owners – Technical Help – Edition 38 Forums

Sign up for a new account in our community. Posted June 20, Karl emerald sent an e-mail saying that if it happens again then it could well be a fault with the car, but its all wired as to their instructions, so cant see that it is.

Posted August 1, Posted December 13, Sign up for a new account in our community. ToyotecApr 3, Yes, my password is: Sep 3, Likes Received: I hope this will work for other people which i’m sure it will, and also save a few quid by not having to Buy Tacho Converters etc. If i tachl emerald i dont know what to ask about as there are no markings on it?